Hardware options installation 63
15.
Install the fans into locations 1 and 2.
16. Install the air baffle (on page 33).
17. Install the access panel (on page 28).
18. Install the server into the rack.
19. Connect each power cord to the server.
20. Connect each power cord to the power source.
21. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.
Memory options
This server supports multiple DIMM types:
• Regular RDIMMs
• LRDIMMs
• Regular RDIMMs and NVDIMM-Ns
NVDIMM-Ns are supported when installed together with a regular RDIMM on the same system with
an HPE Smart Storage Battery. For more information on NVDIMM-Ns and persistent memory, see
the Hewlett Packard Enterprise website (http://www.hpe.com/info/persistentmemory) and the
product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
IMPORTANT:
This server does not support mixing LRDIMMs or RDIMMs. Attempting to mix
any combination of these DIMMs can cause the server to halt during BIOS initialization.
All types are referred to as DIMMs when the information applies to all types. When specified as LRDIMM
or RDIMM, the information applies to that type only. All memory installed in the server must be the same
type.
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To Next Page
Loading...
