Hardware options installation 75
Universal media bay option
The following procedure provides the steps to install the universal media bay option, route the VGA and
USB cables, and install an optional optical disk drive. The universal media bay option also accommodates
the two-bay SFF front drive cage option. For information on installing this option, see "Two-bay SFF front
drive cage option (on page 99)."
1. Power down the server (on page 26).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 26).
o Remove the server from the rack (on page 27).
4. Remove the access panel (on page 27).
5. Remove the air baffle (on page 32).
6. Remove the fan cage (on page 29).
7. Remove the bay blank.
To Next Page
Loading...
