Hardware options installation 48
• If a blank is installed in bay one, then install the Drive bay 1 airflow label (814814-001) as indicated.
Installing the Express Bay drive cage
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause ESD.
To install the component:
1. Back up all server data.
2. Power down the server (on page 26).
3. Do one of the following:
o Extend the server from the rack (on page 26).
o Remove the server from the rack (on page 27).
4. Remove the access panel (on page 27).
5. Remove the air baffle (on page 32).
6. Remove the fan cage (on page 29).
To Next Page
Loading...
