Hardware options installation 91
o
Connected to an HPE 12G SAS Expander Card
10. Install the fan cage.
11. Install the access panel (on page 28).
12. Slide the server into the rack.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server ("Powering up the server" on page 26).
Eight-bay SFF front drive cage option for bay 2
To install the component:
1. Power down the server (on page 26).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 26).
To Next Page
Loading...
