HP ProLiant ML150

Replacing Parts
5-8 HP ProLiant ML150 Server Operations and Maintenance Guide
HP CONFIDENTIAL Codename: Stone Soup Part Number: 343329-001 Last Saved On: 8/14/03 10:30 AM
15. Place the system board and any cables in an anti-static container.
16. Remove the replacement system board and any cables from the anti-static shipping
container.
17. Place the system board on an anti-static pad and set all jumper connections and settings
as recorded during the system board removal.
18. Place the system board in the chassis aligning the rear panel connectors to the rear chassis
and the mounting holes in the board with the holes in the chassis.
19. Snap the board into place.
20. Install the ten screws securing the system board to the chassis.
21. Replace memory and processors.
NOTE: A tube of grease is provided with the replacement system board. One half of the tube should be
used for each processor.
a. Wipe the grease off of the heatsink and processor.
b. Place a round dollop of the grease in the center of the CPU heat spreader.
c. Push the heatsink straight down to evenly spread the grease.
d. Install the heatsink to the CPU.
22. Replace all cables that were removed.
23. Replace any removed accessory boards.
24. Return the machine to its upright position.
25. Replace the system fan.
26. Connect the power cord and any external cables to the server.
27. Close the side panel.
28. Power up the server and return it to normal operation.