Removing the front bezel
Procedure
1. Insert a small flat head or Torx screwdriver into one of the bezel release holes on the bottom of the
module.
2. Push the screwdriver until that side of the bezel is released and then rotate that corner out slightly so
the latch does not re-engage.
3. Release the other latch and then rotate that corner out slightly.
4. Rotate the bottom of the bezel away from the front of the module.
Installing the front bezel
Procedure
1. Place the top tabs of the bezel into the slots on the top of the module.
Removing the front bezel 149
To Next Page
Loading...
