7. Click Finish.
You can return to either partition wizard at any time to change the partition configuration.
Using the Initial Configuration Wizard
The wizard guides you through setting the administrator password, configuring the timezone, date and
time, and library network settings, and then starting an initial system test. You can skip items and stop the
wizard at any time.
Procedure
1. Configure the network settings and set the initial administrator RMI password from the OCP.
2. Initiate the wizard from the RMI to complete the remaining configurations.
Managing the library configuration
NOTE:
The library only supports FAT-32 formatted USB flash devices. FAT-32 is the most common flash drive
format.
Procedure
• Save the library configuration to a file
• Restore the library configuration from a file
• Reset the library configuration to the default settings
• Save the library configuration to a file
56 Using the Initial Configuration Wizard
To Next Page
Loading...
