To disable library-managed encryption, set the encryption mode to Controlled by Backup
Application. When encryption is disabled for a partition, encrypted media in that partition cannot be
read until the same encryption method is enabled.
3. Click Submit.
MSL Encryption Kit configuration
The Configuration > Encryption > USB—MSL Encryption Kit screen displays information about the
key server token and provides access to enter the key server token password and configure a new key
server token. Access to this screen is only available to the security user.
For additional information on using the encryption kit, see the HPE StoreEver MSL Encryption Kit User
Guide on the Hewlett Packard Enterprise Support website: http://www.hpe.com/support/manuals. The
terms “token PIN” and “token password” are used interchangeably in the encryption kit documentation.
Entering the key server token password when using the MSL Encryption Kit
Procedure
1. Navigate to the Configuration > Encryption > USB—MSL Encryption Kit screen.
2. Verify that the correct key server token is available.
3. Enter the Token Password and then click Submit.
Viewing the keys on the key server token when using the MSL Encryption Kit
Procedure
1. Navigate to the Configuration > Encryption > USB—MSL Encryption Kit screen.
2. If the Keys on the Key Server Token area is not visible, click Gather Key Information.
3. Expand the Keys on the Key Server Token area to see the keys on the key server token.
Changing the key server token password when using the MSL Encryption Kit
Procedure
1. Navigate to the Configuration > Encryption > USB—MSL Encryption Kit screen.
2. Expand the Password Management section.
3. Enter the current and new key server token passwords.
4. The key server token password must be at least 8 characters and no longer than 16 characters. The
key server token password must contain at least one lower case letter, one upper case letter, and at
least two digits.
5. Click Submit.
MSL Encryption Kit configuration 77
To Next Page
Loading...
