b. Lower the front of the cover until the latches engage on both sides.
Moving the bottom cover plate
Procedure
1. Remove the bottom cover plate from a module.
a. If the module is not installed in a rack with access to the bottom, lift the module front end by about
16 cm, using the rear of the module as a pivot point.
You will need someone to hold the module while you remove the bottom cover plate.
b. Support the bottom cover with one hand. Insert a small flathead screwdriver or Torx screwdriver
into the slot and slide about 4 mm sideways to unlock the spring loaded lock.
36 Moving the bottom cover plate
To Next Page
Loading...
