Encryption configuration
The library supports multiple methods of encryption. The encryption method is configured for each
partition.
Encryption is configured from the Configuration > Encryption screen.
NOTE:
The library goes offline when the encryption configuration is changed.
Setting the default configuration mode for new partitions
Prerequisites
Logged in to the RMI as the security user
Procedure
1. Navigate to the RMI Configuration > Encryption screen.
2. In the Set Default Encryption Mode for new Partitions, select a mode.
3. To update the setting for all existing partitions, click Apply to all existing partitions.
4. Click Submit.
Allowing the administrator to configure encryption with the Expert Partition Wizard
By default, the security user must configure encryption. With this setting, library administrator users can
configure encryption with the Expert Partition Wizard.
Prerequisites
Logged in to the RMI as the security user
Procedure
1. Navigate to the Configuration > Encryption screen.
2. Select Allow Administrator encryption configuration during Expert Partition Wizard.
3. Click Submit.
Setting the encryption mode for a partition
Prerequisites
Logged in to the RMI as the security user
Procedure
1. Navigate to the Configuration > Encryption screen.
2. In the Set Encryption Mode per Partition section, select an encryption mode for one or more
partitions.
76 Encryption configuration
To Next Page
Loading...
