3. Tighten the blue captive thumbscrews with your fingers or a #2 Phillips screwdriver until it is finger
tight. Do not over tighten.
4. Attach the AC power cord to the new power supply.
Powering on the library
Procedure
1. Plug the power cables into the power connectors on each module and into power outlets.
TIP:
If a module has two power supplies, plug each power cord into a different AC power circuit to
increase redundancy.
2. To use the RMI, connect an Ethernet cable from MGMT Ethernet port on the base module controller to
your network.
3. Power on the library by pressing the power button on the base module just below the OCP; the green
light and OCP will illuminate.
When the library is powered on, it performs the following procedures:
• Inventory the tape cartridges in the magazines
• Check the firmware version on all modules
• Configure the tape drives
• Confirm the presence of the existing modules
• Search for any new modules
130 Powering on the library
To Next Page
Loading...
