Verifying the installation
Procedure
1. Verify that the library initializes correctly, and that the status is Ready.
2. Verify that the library detects all of the library components from the RMI Status > Partition Map >
Configuration Status screen.
If any expansion modules, power supplies, or tape drives are not detected, verify that all cords, cables,
and alignment mechanisms have been properly installed.
3. If using the MSL Encryption Kit, you might need to enter the token password.
For troubleshooting information, see the user guide available from the information library.
4. Resume host operations.
162 Verifying the installation
To Next Page
Loading...
Need help?
General