Event
code
Message text and description Details and solution
2087 Error accessing the backplane flash
memory.
Reboot the library.
2088 Failure moving to the lowest vertical
position of the library, check for
obstructions on the bottom cover.
For proper operation, the robotic assembly must
be able to reach the bottom of the library.
1. Power off the library by pressing the front
power button for 5 seconds and then select
the Default Park location.
2. Remove the left magazine from the lowest
library module and verify that the entire
bottom cover is free of objects that might
obstruct the robotic assembly path.
3. After clearing any obstructions, replace the
magazine and then power on the library.
The library will perform its power-on
sequence and inventory.
4. Verify that no further critical events were
generated.
Warning events
Table 18: Warning events
Event
code
Message and description Details and solution
4000 A reported drive canister fan speed is too
slow.
Ensure that there are no obstructions to the
drive fans.
4001 There is a Fibre Channel Loop ID conflict. Change the FC to fabric or use a different
loop setting.
4002 A drive sent a clean request. Clean the drive with an approved cleaning
cartridge.
Table Continued
Warning events 215
To Next Page
Loading...
