• +Configuration-Critical, Warning, and Configuration events are sent.
• +Informational-All events are sent.
4. In the Server field, enter the remote syslog server hostname or IP address.
5. Configure the Server Port.
The default port for the selected protocol will be selected. You can choose one of the default ports or
configure a custom port.
6. Configure the Transport Protocol.
TCP and UDP are supported. The default is TCP.
7. Click Submit.
Configuring event notification parameters
From the Configuration > Network Management > SMTP screen, you can enable SMTP (Simple Mail
Transfer Protocol) functionality and configure e-mail notification of library events. The library must have
network access to an SMTP server.
Procedure
1. Navigate to the Configuration > Network Management > SMTP screen.
2. If SMTP is not enabled, click SMTP Enabled.
3. When enabled, the remaining configurations are active.
4. Configure SMTP options:
a. Notification Level — The types of events for which the library should send e-mail
• Inactive—No events are sent.
• Critical—Only critical events are sent.
• + Warnings—Only critical and warning events are sent.
• + Configuration—Only critical, warning, and configuration events are sent.
• + Information—All events are sent.
b. SMTP Server —Hostname or IP address of the SMTP server.
c. Security —Security protocol for accessing the SMTP server.
• None
• SSL/TLS
• STARTTLS
d. SMTP Port —SMTP server port. The default port for the selected protocol will be selected. You can
choose one of the default ports or configure a custom port.
e. To Email Address —The address to receive the reported events (for example
firstname.lastname@example.com). Only one email address can be configured.
66 Configuring event notification parameters
To Next Page
Loading...
