Event
code
Message and description Details and solution
4111 Drive firmware upgrade failed because the
specified image is not FIPS Secure Mode
enabled.
This event indicates that an attempt was
made to load FIPS Secure Mode-disabled
firmware into an LTO-7 drive in a partition
that has FIPS Support Mode enabled.
To correct this configuration mismatch,
either disable FIPS Support Mode for the
specified partition or install the FIPS Secure
Mode-enabled firmware variant on the
LTO-7 tape drive.
4112 Move cartridge failed due to cartridge not
seating properly.
1. Look for surrounding events related to
drive problems.
2. Retry the operation with the same source
and destination combination. If the
problem persists, retry the operation with
a different cartridge in the same drive.
3. If the problem follows the cartridge,
inspect the cartridge for physical damage
and remove it from the media pool.
4. If the problem follows the drive, use the
library RMI to pull a drive support ticket
and review the analysis section for
additional information. L&TT must be
installed to view the support ticket.
4113 Move cartridge operation failed due to
cartridge not properly taken over from drive.
Inspect the cartridge for labels or physical
damage that would prevent it from being
removed easily from the slot or drive.
4115 Internal software error. Retry the operation. If the problem persists,
verify that the library is running the latest
released firmware version.
Table Continued
Event codes 231
To Next Page
Loading...
