HP xw6400 User Manual

Screen message Probable cause Recommended action
162—System Options Not Set Configuration incorrect. RTC battery
might need to be replaced.
1. Run Computer Setup (F10 Setup).
2. Set the date and time under Control Panel or in
F10 Setup depending on the operating system.
3. If the problem persists, replace the RTC battery.
163—Time and Date Not Set Invalid time or date in configuration
memory.
RTC battery might need to be
replaced.
CMOS jumper might not be properly
installed.
1. Set the date and time under Control Panel or in
F10 Setup depending on the operating system.
2. If the problem persists, replace the RTC battery.
164—Memory Size Error Memory configuration is incorrect. 1. Run Computer Setup (F10 Setup) or Windows
utilities.
2. Be sure memory modules (if any) are installed
properly.
3. If third-party memory has been added, test using
HP memory only.
4. Verify proper memory module type.
183—Invalid Processor
Jumper Setting
System board jumper improperly set. Reset system board jumpers to match processor and
bus speeds (select models).
201—Memory Error RAM failure. 1. Run Computer Setup (F10 Setup) or Windows
utilities.
2. Be sure that memory and continuity modules are
installed correctly.
3. Verify proper memory module type.
4. Remove and replace memory modules one at a
time to isolate faulty module.
5. Replace the faulty memory modules.
6. If error persists after replacing memory modules,
replace the system board.
202—Memory Type Mismatch Memory modules do not match each
other.
Replace memory modules with matched sets.
207—ECC Corrected Single
Bit Errors in Memory Socket(s)
y,y
Single-bit ECC error. 1. Verify proper memory module type.
2. Insert the DIMM in another memory socket.
3. Replace memory module if problem persists.
212—Failed Processor Processor has failed to initialize. 1. Reseat the processor in its socket.
2. If the processor does not respond, replace it.
213—Incompatible memory
Module in memory Socket(s)
X,X, X
A memory module in memory socket
identified in the error message is
missing critical SPD information or is
incompatible with the chipset.
1. Verify proper memory module type.
2. Insert the DIMM in another memory socket.
3. Replace memory with a module conforming to the
SPD standard.
Table 5-18 POST error messages (continued)
ENWW POST and error messages 129

HP xw6400 Specifications

General

Chipset	Intel 5000X
Storage	SATA or SAS hard drives
Power Supply	650W
Memory	Up to 16 GB DDR2
Expansion Slots	2 PCIe x16
Network	Integrated Gigabit Ethernet
Operating System	Windows XP Professional
Graphics	NVIDIA Quadro FX series