HP xw6400 - Hood Sensor (Smart Cover Sensor)

To remove the top cover:
1. Disconnect power from the system (
Predisassembly procedures on page 57), remove the side
access panel (
Side access panel on page 63), and remove the front bezel (Front Bezel
on page 64).
2. Push a flat screw driver into tab 1 on the rear of the chassis and gently pry the cover upward.
3. Push the top cover toward the rear of the chassis and lift the cover up 2.
Figure 4-8 Removing the Top Cover
Hood sensor (Smart cover sensor)
To remove the hood sensor:
1. Disconnect power from the system (
Predisassembly procedures on page 57) and remove the side
access panel (
Side access panel on page 63).
2. Disconnect the white 1x3 hood sensor connector from the in-line connector attached to the front
panel harness.
3. Slide the hood sensor forward.
4. Slide the hood sensor forward, push it down, and remove it from the chassis.
66 Chapter 4 Removal and replacement procedures ENWW