4. Remove the fan from the fan housing by applying outward pressure on the card guide while lifting
the fan away.
Figure 4-30 Removing the fan from the card guide
To install the front fan:
1. Place the fan in the card guide with the fan label facing into the card guide.
NOTE Ensure that the fan blows toward the rear of the of the chassis.
2. Place the fan wire through the slot in the card guide.
3. Snap the fan into the card guide.
Battery
The battery that comes with the workstation provides power to the real-time clock and has a minimum
lifetime of about three years.
WARNING! This workstation contains a lithium battery. There is a risk of fire and chemical
burn if the battery is handled improperly. Do not disassemble, crush, puncture, short external
contacts, dispose in water or fire, or expose it to temperatures higher than 140°F (60°C).
CAUTION Before removing the battery, be sure your CMOS settings are backed up as all
CMOS settings are lost when the battery is removed. To back up the CMOS settings, use
Computer Setup and run the Save to Diskette option from the File menu.
82 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
Need help?
General
