EasyManuals Logo

HP xw6400 User Manual

HP xw6400
208 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
Screen message Probable cause Recommended action
501—Display Adapter Failure Graphics display controller. 1. Reseat the graphics card (if applicable).
2. Clear CMOS.
3. Verify that the monitor is attached and turned on.
510—Splash Screen image
corrupted
Splash Screen image has errors. Install latest version of ROMPaq to restore image.
511—CPU, CPUA, or CPUB
Fan not detected
Fan is not connected or might have
malfunctioned.
1. Reseat the fan cable.
2. Reseat the fan.
3. Replace the fan.
512—Chassis, rear chassis, or
front chassis fan not detected
Fan is not connected, might have
malfunctioned.
1. Reseat the chassis, rear chassis, or front chassis
fan cable.
2. Reseat the chassis, rear chassis, or front
chassis fan.
3. Replace the chassis, rear chassis, or front
chassis fan.
514—CPU or Chassis Fan not
detected
CPU fan is not connected or might
have malfunctioned.
1. Reseat the CPU or chassis fan.
2. Replace the CPU or chassis fan.
601—Diskette Controller Error Diskette controller circuitry or diskette
drive circuitry incorrect.
1. Run Computer Setup (F10 Setup).
2. Verify and replace cables.
3. Clear CMOS.
4. Replace diskette drive.
5. Replace the system board.
605—Diskette Drive Type
Error
Mismatch in drive type. 1. Run Computer Setup (F10 Setup).
2. Disconnect any other diskette controller devices
(tape drives).
3. Clear CMOS.
610—External Storage Device
Failure
External tape drive not connected. Reinstall tape drive or press F1 and allow system to
reconfigure without the drive.
611—Primary Diskette Port
Address Assignment Conflict
Configuration error. 1. Run Computer Setup (F10 Setup).
2. Remove expansion cards.
3. Clear CMOS.
912—Computer Cover Has
Been Removed Since Last
System Start Up
N/A No action required.
914—Hood Lock Coil is not
Connected
Hood lock mechanism is missing or not
connected.
1. Reconnect or replace hood locking mechanism.
2. Reseat or replace hood locking mechanism cable.
916—Power Button Not
Connected
The power button is not connected. Connect power button.
Table 5-18 POST error messages (continued)
ENWW POST and error messages 131

Table of Contents

Other manuals for HP xw6400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP xw6400 and is the answer not in the manual?

HP xw6400 Specifications

General IconGeneral
ChipsetIntel 5000X
StorageSATA or SAS hard drives
Power Supply650W
MemoryUp to 16 GB DDR2
Expansion Slots2 PCIe x16
NetworkIntegrated Gigabit Ethernet
Operating SystemWindows XP Professional
GraphicsNVIDIA Quadro FX series

Related product manuals