HP xw6400 User Manual

Screen message Probable cause Recommended action
1792—Secondary Disk
Controller Failure
Hard drive circuitry error. 1. Run Computer Setup (F10 Setup).
2. Clear CMOS.
3. Verify cable seating/jumper settings.
4. Run hard drive diagnostics.
5. Disconnect additional drives.
6. Run the Drive Protection System test if available.
7. Replace the hard drive.
1793—Secondary Controller
or Disk Failure
Hard drive circuitry error. 1. Run Computer Setup (F10 Setup).
2. Clear CMOS.
3. Verify cable seating/jumper settings.
4. Run hard drive diagnostics.
5. Disconnect additional drives.
6. Run the Drive Protection System test if available.
7. Replace the hard drive.
1794—Inaccessible devices
attached to primary IDE
controller
Devices attached to the primary IDE
controller are inaccessible while the
SATA controller is set to “Replace
Primary IDE Controller” in Setup.
1. Run Computer Setup (F10 Setup).
2. Select Storage > Storage Options and set SATA
controller to Add as Separate Controller.
1800—Temperature Alert Internal temperature exceeds
specification.
1. Verify that workstation air vents are not blocked
and cooling fan is running.
2. Verify processor speed selection.
3. Replace the processor.
4. Replace the system board.
1801—Microcode Patch Error Processor not supported by ROM
BIOS.
Upgrade BIOS to proper version.
1802—Processor Not
Supported
The system board does not support the
processor.
Replace the processor with a compatible one.
1803-BIOS Update Needed for
Processor
This BIOS revision does not support
the installed processor.
Install the latest BIOS downloaded from
http://www.hp.com.
1998—Master Boot Record
has been lost
The previously saved copy of the MBR
has been corrupted.
Run Computer Setup and save the MBR of the current
bootable disk.
1998—Master Boot Record
has been changed
The current MBR does not match the
previously saved copy of the MBR.
Use extreme caution. The MBR might have been
updated due to normal disk maintenance activities (disk
manager, fdisk, or format). Replacing the previously
saved MBR in such situations can cause data loss. If
certain that the MBR change is unintentional and
undesired (for example, due to a virus), run Computer
Setup and restore the previously saved MBR copy.
Otherwise, run Computer Setup and either disable
MBR security or save the MBR of the current bootable
disk.
Table 5-18 POST error messages (continued)
134 Chapter 5 System diagnostics and troubleshooting ENWW

HP xw6400 Specifications

General

Chipset	Intel 5000X
Storage	SATA or SAS hard drives
Power Supply	650W
Memory	Up to 16 GB DDR2
Expansion Slots	2 PCIe x16
Network	Integrated Gigabit Ethernet
Operating System	Windows XP Professional
Graphics	NVIDIA Quadro FX series