HPE FlexFabric 5710 Series User Manual

45
Appendix B FRUs and compatibility
matrixes
CAUTION:
• Select fan trays and power supplies with airflow directions that meet the ventilation requirements
at the installation site. As a best practice, make sure the power supplies and fan trays have the
same airflow direction.
• Do not install fan trays of different models on the same switch.
• Do not install power supplies of different models on the same switch.
Table 11 Compatibility matrix between the FRUs and HPE FlexFabric 5710 switches
FRUs HPE 5710-54HF HPE 5710-30HF HPE 5710-54HT HPE 5710-30HT
Power supplies
PSR250-12A Yes Yes No Yes
PSR250-12A1 Yes Yes No Yes
PSR450-12A Yes Yes Yes Yes
PSR450-12A1 Yes Yes Yes Yes
PSR450-12D Yes Yes Yes Yes
Fan trays
X721 front-to-back
fan tray
Yes Yes Yes Yes
X722 back-to-front
fan tray
Yes Yes Yes Yes
CAUTION:
• For adequate heat dissipation, install a fan tray in each fan tray slot and make sure the fan trays
are the same model.
• As a best practice, install power supplies of the same model in 1+1 redundancy for the switch.
Power supplies
CAUTION:
When the switch has power supplies in redundancy, you can replace a power supply without
powering off the switch. Make sure the power supply to be replaced is powered off before you
replace it.
IMPORTANT:
As a best practice, use power supplies of the same model in 1+1 redundancy to power the switch.

HPE FlexFabric 5710 Series Specifications

General

Model	HPE FlexFabric 5710 Series
Power Supply	AC or DC
Operating Temperature	0°C to 45°C
Routing Protocol	OSPF, BGP, RIP
Input Voltage	100-240V AC
Operating Humidity	10% to 90% (non-condensing)
Jumbo Frame Support	Up to 9216 bytes
Management	CLI, SNMP