HPE FlexFabric 5710 Series User Manual

41
An HPE 5710-30HT switch comes with power supply slot PWR1 empty and power supply slot PWR2
installed with a filler module. In Figure 50, two PSR450-12A1 po
wer supplies are installed in the
power supply slots. For more information about installing and removing a power supply, see
"Installing and removing a power supply."
An HPE 5710-30HT switch comes with the four fan tray slots empty. You must install four fan trays of
the same model for the switch. In Figure 50, four X72
1 front-to-back fan trays are installed in the fan
tray slots. For more information about installing and removing a fan tray, see "Installing and removing
a fan tray."
Figure 51
Left side panel
(1) Primary grounding point (2) Auxiliary grounding point
Technical specifications
Table 9 Technical specifications (1)
Item HPE 5710-54HF HPE 5710-30HF
Dimensions
(H × W × D)
44 × 440 × 400 mm (1.73 × 17.32 × 15.75
in)
44 × 440 × 400 mm (1.73 × 17.32 × 15.75 in)
Weight ≤ 10 kg (22.05 lb) ≤ 10 kg (22.05 lb)
Console ports
• 1 × mini USB console port
• 1 × serial console port
• 1 × mini USB console port
• 1 × serial console port
Management
Ethernet ports
• 1 × 10M/100M/1000MBASE-T
copper port
• 1 × SFP port
• 1 × 10M/100M/1000MBASE-T copper
port
• 1 × SFP port
USB ports 1 1
1/10GBASE-T
autosensing
Ethernet ports
N/A N/A
SFP+ ports 48 24
QSFP+ ports Up to 6 Up to 6
QSFP28 ports Up to 2 Up to 2
Fan tray slots 4 4
Power supply
slots
2 2
Input voltage
PSR250-12A/PSR250-12A1/PSR450-12A/PSR450-12A1:
• Rated voltage: 100 to 240 VAC @ 50/60 Hz
• Max voltage: 90 to 290 VAC @ 47 to 63 Hz
PSR450-12D:
• Rated voltage: –48 to –60 VDC
• Max voltage: –36 to –72 VDC

HPE FlexFabric 5710 Series Specifications

General

Model	HPE FlexFabric 5710 Series
Power Supply	AC or DC
Operating Temperature	0°C to 45°C
Routing Protocol	OSPF, BGP, RIP
Input Voltage	100-240V AC
Operating Humidity	10% to 90% (non-condensing)
Jumbo Frame Support	Up to 9216 bytes
Management	CLI, SNMP