HPE FlexFabric 5710 Series User Manual

8
• To secure the switch to the rack, you must install not only mounting brackets, but also chassis
rails and slide rails.
Table 6 Distance requirements between the front and rear rack posts
Switch model Installation method
Minimum distance
between the front and
rear rack posts
Maximum distance
between the front
and rear rack posts
• HPE 5710-54HF
• HPE 5710-30HF
Using mounting
brackets, chassis rails,
and long slide rails
621 mm (24.45 in) 793 mm (31.22 in)
• HPE 5710-54HT
• HPE 5710-30HT
Using mounting
brackets, chassis rails,
and long slide rails
621 mm (24.45 in) 854 mm (33.62 in)
Attaching the mounting brackets, chassis rails, and
grounding cable to the chassis
The switch has two mounting bracket installation positions on its two sides: one near the network
port side and one near the power supply side.
The switch provides a primary grounding point (with a grounding sign) and an auxiliary grounding
point.
Figure 5 Mounting bracket installation positions and grounding positions on the HPE
5710-54HF and HPE 5710-30HF switches
(1) Mounting bracket installation position near the power supply side
(2) Primary grounding point (3) Auxiliary grounding point
(4) Mounting bracket installation position near the port side

HPE FlexFabric 5710 Series Specifications

General

Model	HPE FlexFabric 5710 Series
Power Supply	AC or DC
Operating Temperature	0°C to 45°C
Routing Protocol	OSPF, BGP, RIP
Input Voltage	100-240V AC
Operating Humidity	10% to 90% (non-condensing)
Jumbo Frame Support	Up to 9216 bytes
Management	CLI, SNMP