HPE FlexNetwork 5130 HI SERIES Configuration Guide

122
Step Command Remarks
3. Configure the link type of the
port as access.
port link-type access
By default, all ports are access
ports.
4. (Optional.) Assign the
access port to a VLAN.
port access vlan
vlan-id
By default, all access ports belong to
VLAN 1.
Assigning a trunk port to a VLAN
A trunk port supports multiple VLANs. You can assign it to a VLAN in interface view.
When you assign a trunk port to a VLAN, follow these restrictions and guidelines:
• To change the link type of a port from trunk to hybrid or vice versa, set the link type to access
first.
• To enable a trunk port to transmit packets from its PVID, you must assign the trunk port to the
PVID by using the port trunk permit vlan command.
To assign a trunk port to one or multiple VLANs:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
• Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
• The configuration made in
Layer 2 Ethernet interface
view applies only to the port.
• The configuration made in
Layer 2 aggregate interface
view applies to the aggregate
interface and its aggregation
member ports. If the system
fails to apply the
configuration to an
aggregation member port, it
skips the port and moves to
the next member port. If the
system fails to apply the
configuration to the
aggregate interface, it stops
applying the configuration to
aggregation member ports.
3. Configure the link type of the
port as trunk.
port link-type trunk
By default, all ports are access
ports.
4. Assign the trunk port to the
specified VLANs.
port trunk permit vlan
{ vlan-id-list |
all
}
By default, a trunk port permits
only VLAN 1.
5. (Optional.) Configure the
PVID of the trunk port.
port trunk pvid vlan
vlan-id The default setting is VLAN 1.
Assigning a hybrid port to a VLAN
A hybrid port supports multiple VLANs. You can assign it to the specified VLANs in interface view.
Make sure the VLANs have been created.
When you assign a hybrid port to a VLAN, follow these restrictions and guidelines:
• To change the link type of a port from trunk to hybrid or vice versa, set the link type to access
first.

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English