HPE FlexNetwork 5130 HI SERIES Configuration Guide

28
Figure 5 ARP fast update application scenario
To enable ARP fast update for MAC address moves:
Step Command Remarks
1. Enter system
view.
system-view
N/A
2. Enable ARP fast
update for MAC
address moves.
mac-address mac-move fast-update
By default, ARP fast update for
MAC address moves is disabled.
Enabling SNMP notifications for the MAC address
table
After you enable SNMP notifications for the MAC address table, the device will send SNMP
notifications to the SNMP module to notify the NMS of important events. You can set the notification
sending parameters in SNMP to determine the attributes of sending notifications.
After you disable SNMP notifications for the MAC address table, the device will only send log
messages to the information center module. You can set the output rules and destinations to
examine the log messages of the MAC address table module.
For more information about SNMP notifications and information center, see Network Management
and Monitoring Configuration Guide.
To enable SNMP notifications for the MAC address table:
Step Command Remarks
1. Enter system
view.
system-view
N/A
2. Enable SNMP
notifications for
the MAC address
table.
snmp-agent trap enable mac-address
[
mac-move
]
By default, SNMP notifications
are disabled for the MAC address
table.
Displaying and maintaining the MAC address
table
Execute display commands in any view.

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English