HPE FlexNetwork 5130 HI SERIES Configuration Guide

232
Step Command Remarks
• In Layer 2 aggregate interface view:
lldp agent { nearest-customer |
nearest-nontpmr }
check-change-interval interval
Configuring the advertisable TLVs
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2 Ethernet
interface view,
management Ethernet
interface view, or Layer 2
aggregate interface view.
interface
interface-type interface-number N/A
3. Configure the advertisable
TLVs (in Layer 2 Ethernet
interface view).
• lldp tlv-enable { basic-tlv { all |
port-description | system-capability
| system-description | system-name
| management-address-tlv
[ ip-address ] } | dot1-tlv { all |
congestion-notification |
port-vlan-id | link-aggregation |
protocol-vlan-id [ vlan-id ] |
vlan-name [ vlan-id ] |
management-vid [ mvlan-id ] } |
dot3-tlv { all | mac-physic |
max-frame-size | power } | med-tlv
{ all | capability | inventory |
network-policy [ vlan-id ] ||
power-over-ethernet | location-id
{ civic-address device-type
country-code { ca-type
ca-value }&<1-10> | elin-address
tel-number } } }
• lldp agent nearest-nontpmr
tlv-enable { basic-tlv { all |
port-description | system-capability
| s
ystem-description | system-name
| management-address-tlv
[ ip-address ] } | dot1-tlv { all |
congestion-notification |
port-vlan-id | link-aggregation } }
• lldp agent nearest-customer
tlv-enable { basic-tlv { all |
port-description | system-capability
| system-description | system-name
| management-address-tlv
[ ip-address ] } | dot1-tlv { all |
congestion-notification |
port-vlan-id | link-aggregation } }
By default:
• Nearest bridge
agents can
advertise all types of
LLDP TLVs except
the DCBX TLV,
location
identification TLV,
port and protocol
VLAN ID TLVs,
VLAN name TLVs,
and management
VLAN ID TLVs.
• Nearest non-TPMR
bridge agents
advertise no TLVs.
• Nearest customer
bridge agents can
advertise basic
TLVs and IEEE
802.1
organizationally
specific TLVs.
4. Configure the advertisable
TLVs (in management
Ethernet interface view).
• lldp tlv-enable { basic-tlv { all |
port-description | system-capability
| system-description | system-name
| management-address-tlv
[ ip-address ] } | dot1-tlv { all |
link-aggregation } | dot3-tlv { all |
mac-physic | max-frame-size |
power } | med-tlv { all | capability |
By default:
• Nearest bridge
agents can
advertise all types of
LLDP TLVs (only
link aggregation TLV
in 802.1
organizationally

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English