6
Step Command Remarks
2. Enter Ethernet interface
view.
interface
interface-type
interface-number
N/A
3. Enable EEE energy
saving.
eee enable
By default, EEE energy
saving is disabled.
Setting the statistics polling interval
To set the statistics polling interval in Ethernet interface view:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Ethernet interface
view.
interface
interface-type
interface-number
N/A
3. Set the statistics polling
interval.
flow-interval
interval
By default, the statistics polling
interval is 300 seconds.
To display the interface statistics collected in the last polling interval, use the display interface
command.
To clear interface statistics, use the reset counters interface command.
Enabling automatic negotiation for speed downgrading
Perform this task to enable interfaces at two ends of a link to automatically negotiate about
downgrading their speed when the following conditions exist:
• The interfaces automatically negotiate a speed of 1000 Mbps.
• The interfaces cannot operate at 1000 Mbps because of link restrictions.
This command is applicable only to GE interfaces.
To enable automatic negotiation for speed downgrading:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Ethernet interface
view.
interface
interface-type
interface-number
N/A
3. Enable automatic
negotiation for speed
downgrading.
speed auto downgrade
By default, automatic negotiation
for speed downgrading is
enabled.
Configuring a Layer 2 Ethernet interface
Configuring storm suppression
You can use the storm suppression feature to limit the size of a particular type of traffic (broadcast,
multicast, or unknown unicast traffic) on an interface. When the broadcast, multicast, or unknown
unicast traffic on the interface exceeds this threshold, the system discards packets until the traffic
drops below this threshold.
To Next Page
Loading...
Need help?
General