HPE FlexNetwork 5130 HI SERIES

211
Step Command Remarks
Security Command Reference.
Configuring the customer-side port
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2 Ethernet
interface view.
interface
interface-type
interface-number
N/A
3. Set the link type of the port.
• Configure the port as a trunk
port:
port link-type trunk
• Configure the port as a hybrid
port:
port link-type hybrid
By default, the link type of a
port is
access
.
4. Assign the port to the original
VLANs and the translated
VLANs.
• port trunk permit vlan
vlan-id-list
• port hybrid vlan vlan-id-list
tagged
N/A
5. Configure a many-to-one
VLAN mapping.
vlan mapping uni
{
range
vlan-range-list |
single
vlan-id-list }
translated-vlan
vlan-id
By default, no VLAN mapping
is configured on an interface.
6. Enable DHCP snooping entry
recording.
dhcp snooping binding record
By default, DHCP snooping
entry recording is disabled on
an interface.
Configuring the network-side port
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
N/A
3. Set the link type of the port.
• Configure the port as a trunk
port:
port link-type trunk
• Configure the port as a hybrid
port:
port link-type hybrid
By default, the link type of a
port is
access
.
4. Assign the port to the
translated VLANs.
• port trunk permit vlan
vlan-id-list
• port hybrid vlan vlan-id-list
tagged
N/A
5. Configure the port as a
DHCP snooping trusted port.
dhcp snooping trust
By default, all ports that
support DHCP snooping are
untrusted ports when DHCP
snooping is enabled.
6. Configure the port as an ARP
arp detection trust
By default, all ports are ARP