Figure 16: Removing the drive
5. Insert the replacement hard drive (1) and close the carrier handle (2).
6. Close the hard drive drawer. You will hear it click into place when it is securely closed. The fans will return
to normal speed when both drawers are properly closed.
WARNING:
Pinch hazard—Keep hands out of front and rear of chassis when closing hard drive drawers.
CAUTION:
To prevent improper cooling and thermal damage:
• Do not operate the disk enclosure for an extended period with the drawer open.
• Do not operate the disk enclosure unless all bays are populated with either a component or a
blank.
7. Use the StoreOnce GUI or StoreOnce CLI to check that the firmware on the new component is correct.
NOTE:
Note the output at command completion. It will advise if you need a system reboot or a cold reboot to
install the new firmware revision successfully.
8. If you are using HPE StoreOnce Remote Support, to return to normal mode after maintenance, run the
StoreOnce CLI command:
system disable remoteeventsuppression "Disk Maintenance"
42 Disk replacement
To Next Page
Loading...
