HPRT HM-E200 - ESC - N; Esc 2; ESC 3 N

HM-E200 Programming Manual
10
ESC - n
[Name] Turn underline mode on /off
[Format] ASCII ESC
-
n
Hex 1B 2D n
Decimal 27 45 n
[Range]
0≤ n ≤ 2
48 ≤ n ≤ 50
[Description] turn underline mode on/off, n value as follows:
n
Function
0, 48
underline mode is turn off
1, 49
underline mode ( one dot width) is turn on
2, 50
underline mode ( two dot width) is turn on
[Note] 1) This command is effective for all characters (including the blank space), but not the
blank space set by HT.
2) When underline mode is on, 90°clock wise rotated characters and characters and
white / black reverse characters cannot be underline.
3) When underline mode is off, there is no underline for following characters. Underline
width stays the same, default width: one dot width.
4) Character size change has no effects on underline width.
5) Turn underline mode on / off can be set by ESC !, the command executed at last is
effective.
[Default] n = 0
ESC 2
[Name] Set character line spacing for 30
[Format] ASCII ESC 2
Hex 1B 32
Decimal 27 50
[Description] Selects 3.875 mm (31 0.125 mm) line spacing.
[Notes] The line spacing can be set independently in standard mode and in page mode.
ESC 3 n
[Name] Set character line spacing
[Format] ASCII ESC 3 n
Hex 18 33 n
Decimal 27 51 n
[Range] 0 ≤ n ≤ 255
[Description] Sets the line spacing to [n 0.125 mm].
[Notes] The line spacing can be set independently in standard mode and in page mode.
[Default] n =31.