HPRT HM-E200 - 3 Multi-Byte Code Characters Commands List; FS! N

HM-E200 Programming Manual
35
3. Multi-byte code characters commands list
FS! n
[Name] Set print mode(s) for Kanji characters
[Format] ASCII FS ! n
Hex 1C 21 n
Decimal 28 33 n
[Range] 0 ≤ n ≤ 255
[Description] Sets the print mode for Kanji characters, using n as follows:
[Notes] When both double-width and double-height modes are set (including right-and
left-side character spacing), quadruple-size characters are printed.
The printer can underline all characters (including right-and left-side character
spacing), but cannot underline the space set by HT and 90° clockwise- rotated
characters.
The thickness of the underline is that specified by FS ,regardless of the
character size.
It is possible to emphasize the Kanji character using FS W or GS !; the
setting of the last received command is effective.
It is possible to turn underline mode on or off using FS
[Default] n = 0
[Reference] FS_,FS W, GS
n
Function
0, 48
Turns off underline mode for Kanji characters
1, 49
Turns on underline mode for Kanji characters (1-dot thick)
2, 50
Turns on underline mode for Kanji characters (2-dot thick)