4.7. USING INSTRUMENT WHILE IT IS HANGING AND ATTACHED TO A STRAP
For measurements where it is useful to hang the instrument, it is advisable to remove the
cover from the case. To do so, proceed as follows:
1. Open the case and turn the two locking pins as shown in Fig. 5
Fig. 5: Removing the cover from the instrument case - Step 1
2. Remove the two locking pins by pulling them outwards as shown in Fig. 6
Fig. 6: Removing the cover from the instrument case - Step 2
3. Remove the case cover from its housing as shown in Fig. 7
To Next Page
Loading...
