Step Action
Configure RAID. Configure RAID for the server. For details, see the Huawei V5
Server RAID Controller Card User Guide.
Configure the BIOS. Configure the server BIOS, including setting the boot option
priority and BIOS password.
Install an OS. Install an OS for the server.
4.6.3 Setting the Management Network Port IP Address
You can set the IP address using any of the following methods:
Using the iBMC WebUI
For details, see the Huawei Rack Server iBMC User Guide.
Using the iBMC CLI
For details, see the Huawei Rack Server iBMC User Guide.
Using the BIOS
Step 1 Log in to the Remote Virtual Console. For details, see 14.2 Logging In to the Remote
Virtual Console.
Step 2 On the Remote Virtual Console, click or on the menu bar.
Step 3 Choose Reset.
The system displays "Are you sure to perform this operation?"
Step 4 Click Yes.
The server restarts.
Step 5 When information shown on the following screen is displayed, press Delete or F4 to access
the BIOS setup utility.
NOTE
l To go to the Front Page, press F11 or F3.
l To go to PXE, press F12.
l To go to the Smart Provisioning GUI, press F6.
2288H V5 Server
User Guide
4 Setup
Issue 04 (2018-09-04) Copyright © Huawei Technologies Co., Ltd. 95
To Next Page
Loading...
