5.6 DVD Drive
To install a DVD drive, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see 12 Preventing Electrostatic Discharge.
Step 2 Power off the server. For details, see 3.2 Powering Off the Server.
Step 3 Remove the power cables. For details, see 3.7 Removing Cables from a PSU.
Step 4 Remove the server. For details, see 3.3 Removing the Server and Guide Rails.
Step 5 Remove the chassis cover. For details, see 3.4 Removing the Chassis Cover.
Step 6 Remove the air duct or the built-in drive assembly. For details, see 3.8 Removing the Air
Duct or 3.10 Removing the Built-in Drive Assembly.
Step 7 Remove all fan modules. For details, see 3.6 Removing a Fan Module.
Step 8 Press and hold down the latches on both sides of a fan module bracket, and lift the fan module
bracket. See Figure 5-27. Use the same method to lift the other fan module bracket.
Figure 5-27 Removing a fan module bracket
Step 9 Take a spare DVD drive out of its ESD bag.
Step 10 Tighten two M2 flat-head screws using the Phillips screwdriver to secure the plastic latch to
the DVD drive. See (1) in Figure 5-28.
2288H V5 Server
User Guide
5 Optional Part Installation
Issue 04 (2018-09-04) Copyright © Huawei Technologies Co., Ltd. 135
To Next Page
Loading...
