4.5.2 Connecting Cables to a Mouse, Keyboard, and VGA Port
The front and rear panels of the server have DB15 VGA ports but no standard PS/2 port for a
keyboard or mouse.
Connect a keyboard or mouse to a USB port on the front or rear panel if needed, either
directly or with a USB-to-PS/2 cable.
Step 1 Wear an ESD wrist strap. For details, see 12 Preventing Electrostatic Discharge.
Step 2 Plug the USB connector on the PS/2 cable into the USB port on the front or rear panel of the
server.
Step 3 Connect the connectors on the other end of the PS/2 cable to the keyboard and mouse.
Step 4 Connect the DB15 connector on the VGA cable to the VGA port on the front or rear panel of
the server and tighten the two screws.
Step 5 Connect the other end of the VGA cable to the VGA port on the monitor and tighten the two
screws.
Figure 4-14 Connecting PS/2 and VGA cables
----End
4.5.3 Connecting a Network Cable
Before connecting or replacing a network cable, use a network cable tester to check whether
the new network cable is functional.
The new and old cables must be of the same model or be compatible.
Before installing a network cable to a network port, check that the network cable connector is
intact and the pins have no sundries or deformation.
Step 1 Wear an ESD wrist strap. For details, see 12 Preventing Electrostatic Discharge.
Step 2 Check the model of the new network cable.
A network cable with the shielding function is recommended. According to professional EMC
test results, when static is generated, a network cable without the shielding function can cause
the system to suspend or restart.
2288H V5 Server
User Guide
4 Setup
Issue 04 (2018-09-04) Copyright © Huawei Technologies Co., Ltd. 81
To Next Page
Loading...
