The power cable connection methods are as follows:
l Using no power cable
l Using a 6-pin power cable
Connect the 6-pin connector on the GPU to an 8-pin connector on either side of the riser
card. See (1) in Figure 5-26.
l Using an 8-pin power cable
Connect the 8-pin connector on the GPU to an 8-pin connector on either side of the riser
card. See (2) in Figure 5-26.
l Using an 8-pin (one-to-two) power cable
Connect the 8-pin connector on the GPU to the 8-pin connectors on both sides of the
riser card. See (3) in Figure 5-26.
Figure 5-26 Connecting power cables to a GPU
Step 12 Install the riser card tray. For details, see 3.13 Installing a Riser Card Tray.
Step 13 Install the chassis cover. For details, see 3.5 Installing the Chassis Cover.
Step 14 Install the server. For details, see 4.4 Installing the Server on Guide Rails.
Step 15 Connect the power cables. For details, see 5.4 PSU.
Step 16 Power on the server. For details, see 3.1 Powering On the Server.
Step 17 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the Huawei Rack Server iBMC User Guide.
----End
2288H V5 Server
User Guide
5 Optional Part Installation
Issue 04 (2018-09-04) Copyright © Huawei Technologies Co., Ltd. 134
To Next Page
Loading...
