Huawei AR1200 Series - Uploading a GTL License File; Activating the GTL License File

No. Data
1 GTL license file name
9.2.2 Uploading a GTL License File
The GTL license file that has been applied for can be activated only after the file has been
uploaded to the storage medium on a device.
Context
Before uploading a GTL license file, run the dir command to check that the storage media has
adequate free space to store the GTL license file.
Procedure
Step 1 Run:
dir *.dat
Check whether the GTL license file is saved to flash:.
If the GTL license file is not saved, upload the GTL license file to flash:.
Step 2 Run:
copy source-filename destination-filename
The GTL license file is uploaded to flash:.
NOTE
A user who wants to upgrade a GTL license must run the license revoke command to obtain an invalidation
code, and then use this code to apply to Huawei for a new GTL license. This user also needs to load the
new GTL license file to the main control board.
----End
9.2.3 Activating the GTL License File
After activating the GTL license, you are allowed to operate the corresponding service modules.
Procedure
l Activate the GTL license for the first time.
1. Run:
license active file-name
The GTL license is activated and you obtained permission.
NOTE
If you use the GTL license for the first time, buy the GTL license file from Huawei.
l Upgrade the GTL license.
1. Run:
license revoke
The GTL license invalidation code is returned.
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Basic Configuration 9 Upgrade and Maintenance
Issue 04 (2012-05-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
192