Huawei AR1200 Series - Example for Logging in by Telnet

To Next Page

To Previous Page

Figure 5-10 Communication parameter settings

Step 3 Power on the router. After the self-check is complete and the router is started, you are prompted

to press Enter.

At the prompt (usually <Huawei>), you can run commands to view the status of the router or

configure the router.

----End

5.6.2 Example for Logging In by Telnet

In this example, you can set user login parameters to log in to the router from the PC or other

terminals using Telnet.

Networking Requirements

You can log in to the router on other network segments through the PC or other terminals to

perform remote maintenance.

Huawei AR1200 Series Enterprise Routers

Configuration Guide - Basic Configuration 5 Configuring User Login

Issue 04 (2012-05-15) Huawei Proprietary and Confidential

Other manuals for Huawei AR1200 Series