Huawei AR1200 Series - Checking the Configuration

Figure 5-4 Windows CLI
2. Press Enter to display the command line prompt, such as <HUAWEI>, for the system
view. This indicates that you have accessed the Telnet server.
If the password or AAA authentication mode has been set on the device, you must enter
the login user name and password, and press Enter. The command line prompt of the user
view is displayed, as shown in Figure 5-5.
Figure 5-5 Login
----End
5.3.5 Checking the Configuration
After logging in to the system using Telnet, you can view the connection status of each user
interface including the current user interface, and status of all established TCP connections.
Prerequisites
Configurations for Telnet logins are complete.
Procedure
l Run the display users [ all ] command to check information about users logged in to user
interfaces.
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Basic Configuration 5 Configuring User Login
Issue 04 (2012-05-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
82