Huawei AR1200 Series - Checking the Configuration

The TTY user interface view is displayed.
3. Run:
authentication-mode password
The authentication mode is set to password authentication.
4. Run:
set authentication password { cipher | simple } password
The authentication password is configured.
l Configuring non-authentication
1. Run:
system-view
The system view is displayed.
2. Run:
user-interface tty first-ui-number [ last-ui-number ]
The TTY user interface view is displayed.
3. Run:
authentication-mode none
The authentication mode is set to none.
----End
4.4.6 Checking the Configuration
After configuring a TTY user interface, you can view information about the user interface and
its physical attributes and configurations, a local user list, and online users.
Prerequisites
The configurations of the user management function are complete.
Procedure
l Run the display users [ all ] command to check information about the user interface.
l Run the display user-interface tty ui-number1 [ summary ] command to check physical
attributes and configurations of the user interface.
----End
Example
Run the display users command to view information about the current user interface.
<Huawei> display users
User-Intf Delay Type Network Address AuthenStatus AuthorcmdFlag
0 TTY 0 00:00:44
Username : Unspecified
Run the display user-interface tty ui-number1 [ summary ] command to view the physical
attributes and configurations of the user interface.
<Huawei> display user-interface tty 17
Idx Type Tx/Rx Modem Privi ActualPrivi Auth Int
17 TTY 17 9600 - 0 - N 2/0/0
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Basic Configuration 4 Configuring User Interfaces
Issue 04 (2012-05-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
63