Huawei E9000 User Manual

4. Repeat 1 to 3 to install the other management module (if two management modules are
required).
----End
3.8 Installing Switch Modules or Pass-Through Modules
The procedure for installing a pass-through module is the same as that for installing a switch
module.
During operations, wear protective gloves to prevent personal injury.
Procedure
Step 1 Determine the slots for installing the switch modules or pass-through modules.
A maximum of four switch modules or pass-through modules can be installed in an E9000
chassis. Figure 3-24 shows the slot numbers of the switch modules or pass-through modules.
Figure 3-24 Slot numbers of the switch modules or pass-through modules
E9000 Server
User Guide
3 Installing the E9000
Issue 25 (2019-11-30) Copyright © Huawei Technologies Co., Ltd. 63

Huawei E9000 Specifications

General

Form Factor	12U chassis
Blade Slots	16 half-width slots or 8 full-width slots
Switch Modules	GE, 10GE, and IB switches
Management Modules	Two hot-swappable management modules for redundancy
Power Supply	Supports up to 6 hot-swappable power supply units (PSUs)
Cooling	Redundant hot-swappable fan modules
Processor Options	Intel Xeon E5-2600 v3/v4 series processors (depending on blade type)
Memory Capacity	Up to 1.5 TB per blade
Storage Options	SAS/SATA/SSD options in blades
Networking	10GE/40GE networking options
Management	Huawei iBMC (Intelligent Baseboard Management Controller)
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, Windows Server, VMware ESXi