Huawei E9000 - Adding Components of Compute Nodes

Table 8-2 Recording the software versions of existing modules and expansion modules
Module Name Related
Component
Existing Module
Version
Expansion Module
Version
Management
module
CPLD - -
Firmware - -
Fan module - -
Compute node iBMC or iMana - -
BIOS - -
CPLD - -
Switch module BMC - -
BIOS - -
Switching plane - -
Step 4 Check whether the expansion module versions match the existing module versions. For
details, see the version mapping information on the Software Download tab page.
l If yes, go to Step 5.
l If no, upgrade the software of the expansion modules based on the version mapping
information. For details, see the E9000 Server V100R001 Upgrade Guide. To obtain the
software upgrade packages, choose Support > Intelligent Servers > Blade Servers >
E9000 Chassis, and click the Software Download tab. Go to Step 5 after the upgrade is
complete.
Step 5 Configure the expansion modules. For details, see "Configuring the CHxxx" in the CHxxx
Compute Node User Guide or "Configuring the CXxxx" in the CXxxx Switch Module User
Guide.
Step 6 Configure the networking between the compute node NICs and switch modules by referring
to the E9000 Blade Server Mezzanine Module-Switch Module Interface Mapping Tool
and site requirements.
----End
8.3 Adding Components of Compute Nodes
Add the components of E9000 compute nodes, including CPUs, DIMMs, hard disks, and
mezzanine cards.
NO TICE
Ensure that service data of compute nodes has been backed up before the compute nodes are
powered off.
E9000 Server
User Guide
8 Expanding the E9000 Capacity
Issue 25 (2019-11-30) Copyright © Huawei Technologies Co., Ltd. 155