----End
6.3.9 Installing Cables and Optical Modules
Install cables and optical modules after switch module replacement.
Procedure
Step 1 Connect a GE network cable or serial cable.
Figure 6-29 Connecting a GE network cable or serial cable
l The BMC serial port, SYS serial port, and GE electrical port are standard RJ-45 ports, and their
cables can be installed in the same way.
l Before installing a network cable to a network port, check that the network cable connector is intact
and the pins have no sundries or deformation.
Step 2 Insert the optical module and optical cable into the 10GE or 8 Gbit/s FC optical port.
1. Determine the type and installation position of the optical module based on site
requirements.
2. Horizontally insert the optical module into the optical port until the optical module snaps
into place. See Figure 6-30.
Figure 6-30 Installing an optical module
E9000 Server
User Guide
6 Parts Replacement
Issue 25 (2019-11-30) Copyright © Huawei Technologies Co., Ltd. 130
To Next Page
Loading...
