Step 2 On the basis of the reference points, mark the mounting positions for the four
corner ttings of a pre-fab. module using an ink fountain and long leather
measuring tape.
When marking the mounting positions for corner ttings, ensure that the four
lines form a rectangle.
Figure 4-1 Concrete platform (unit: mm)
(1) Concrete platform
(2) Ground (3) Angle steel
----End
4.1.2 Removing the Pre-fab. Module Protective Cover
Prerequisites
The weather condition is good without rain or snow.
Context
A protective cover is installed to protect the pre-fab. module during transportation.
Preparations
Tools: safety helmet, safety belt, step ladder, protective gloves, utility knife
Materials: none
Skill requirement: common technician
FusionDC1000A Prefabricated All-in-One Data
Center
Installation Guide (IT Scenario) 4 Installing a Pre-fab. Module
Issue 01 (2021-04-20) Copyright © Huawei Technologies Co., Ltd. 31
To Next Page
Loading...
Need help?
General