Huawei FusionDC1000A - Fire Detection for Lithium Battery Modules; Acronyms and Abbreviations

To Next Page

To Previous Page

9 Installing Cables Outside the Pre-fab.

Module

9.1 Connecting Input Power Cables for the Pre-fab.

Module

Preparations

Tools: crimping tool, Phillips screwdriver, adjustable wrench, cable cutter, heat gun

Materials: cable tie, cable, terminal, heat shrink tubing

Skill requirement: skilled technician

Procedure

Step 1 Open the door of the power PDB.

Step 2 Remove the plugs from the two cable holes at the bottom of the power PDB.

Figure 9-1 Removing the plugs from the cable holes

Step 3 Remove the transparent cable protection panel from the power PDB busbar.

FusionDC1000A Prefabricated All-in-One Data

Center

Installation Guide (IT Scenario) 9 Installing Cables Outside the Pre-fab. Module

Other manuals for Huawei FusionDC1000A