Figure 5-1 Composition of the external cable tray
(1) Long cable tray (2) Short cable tray (3) Fastener
(4) M10 bolt assemblies (5) M8 bolt assemblies
Procedure
Step 1 Locate the external cable tray installation position, and remove the rubber plugs
from the corresponding mounting holes in the pre-fab. module using a Phillips
screwdriver.
Step 2 Secure the short cable tray to the ports reserved on the pre-fab. module.
FusionDC1000A Prefabricated All-in-One Data
Center
Installation Guide (IT Scenario)
5 Installing External Accessories for the Pre-fab.
Module
Issue 01 (2021-04-20) Copyright © Huawei Technologies Co., Ltd. 49
To Next Page
Loading...
