Procedure
Step 1 Remove the bolts from the sliding door fasteners using an adjustable wrench, and
remove the sliding door fasteners.
Figure 7-9 Removing the sliding door fasteners
Step 2 Remove the piston rings, and install them in the screw holes in the oor under the
sliding door and the beam above the sliding door.
The plugs are packed and secured above the door handle before delivery.
----End
Follow-up Procedure
When a pre-fab. module needs to be relocated, refer to the preceding steps to
adjust the sliding door fasteners in reverse order to secure the sliding doors.
FusionDC1000A Prefabricated All-in-One Data
Center
Installation Guide (IT Scenario) 7 Removing Transport Protection Materials
Issue 01 (2021-04-20) Copyright © Huawei Technologies Co., Ltd. 67
To Next Page
Loading...
