Huawei NE40E - Page 281

NE40E
Hardware Description
1 Hardware Description
Issue 01 (2018-05-03)
267
Name
Description
If this indicator is off, no alarm is generated.
ACT (green)
If this indicator is steady on, the board functions as the master one.
If this indicator is off, the board functions as the slave one.
Optical interface
L/A
If this indicator is steady on, the link is Up.
If this indicator is blinking, data is being transmitted and received.
If this indicator is off, the link is Down.
MGMT-ETH
LINK (green)
If this indicator is steady on, the link is Up.
If this indicator is off, the link is Down.
MGMT-ETH ACT
(yellow)
If this indicator is blinking, data is being transmitted and received.
If this indicator is off, no data is being transmitted or received.
USB OFL
USB OFL indicator, reserved for further expansion.
Table 1-227 Management interfaces
Interface
Name
Interfac
e Type
Connec
tor
Type
Description
Cable
FSP0,
FSP1
Serial
interface
RJ45
Reserved. It
functions as an
interface for
fast chassis
switchovers.
8-core shielded cable
GE/10GE
GE/10GE
SFP+/S
FP
Reserved
cascading
interface.
Super category 5 shielded twisted
pair
MGMT-E
TH
Ethernet
interface
(10M/100
M/1000
M
Base-TX
autonegot
iation)
RJ45
It connects to
an NMS and
can work in
half-duplex or
full-duplex
mode.
Super category 5 shielded twisted
pair
CON
RS-232
serial
interface
RJ45
It connects to
the console for
on-site system
configuration.
Baud rate: 9600
bit/s (default
value), which is
configurable.
8-core shielded cable
AUX
RS-232
RJ45
It connects to
-