HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 11-3 Upgrading multiple endpoints in batches
Step 6 In area 1 shown in Figure 11-2, enter the number of the endpoints you want to upgrade, for
example, 4.
Step 7 In area 3 shown in Figure 11-2, enter the IP addresses of the endpoints you want to upgrade.
Step 8 In area 4 shown in Figure 11-2, enter the upgrade passwords of the endpoints you want to
upgrade.
Step 9 In area 2 shown in Figure 11-2, select the endpoints you want to upgrade and click Upgrade.
To improve upgrade efficiency when the network bandwidth is insufficient, you can press Ctrl+ALT+C
in the window shown in Figure 11-1, and then set the upgrade policy in the displayed window.
----End
Upgrading Specified Software Modules
Step 1 Power on the computer and endpoint.
Step 2 Extract the compressed software upgrade package on the computer.
Step 3 Run UpgMaster.exe to display the window shown in Figure 11-1.
Step 4 (Optional) Click Browser and select the te.dat file.
By default, the path of the te.dat file is displayed in Upgrade File.
Step 5 Press Ctrl+ALT+P to display the Pack Upgrade File window.
Step 6 In the upgrade file list area, select the software modules you want to upgrade.
Step 7 Click Pack File to pack the selected software modules into a .dat file. Save the file to the
computer, for example, save the file as tepart.dat to the computer.
Step 8 In the displayed dialog box, click OK.
Step 9 (Optional) In the window shown in Figure 11-1, click Browser and select the tepart.dat file
you saved in Step 7.
To Next Page
Loading...
Need help?
General
