Huawei PowerCube 1000 - Setting 57 V Constant Voltage Output Parameters; Setting the Number of Dgs; Setting Parameters for the Reused DG

----End
12.2.7 Setting 57 V Constant Voltage Output Parameters
NO TE
This parameter is set only in the lithium battery–only scenario.
Table 12-10 Setting 57 V constant voltage output parameters
Main
Menu
Second-Level
Menu
Third-Level
Menu
Fourth-Level
Menu
Setting
Parameters
Settings
Li Battery Basic
Parameters
Work Mode 48 V Mode/57 V Mode
NOTE
Set the output voltage for the lithium
battery as required.
12.2.8 Setting the Number of DGs
Table 12-11 Setting the number of DGs and DG scheduling mode
Main Menu
Second-Level
Menu
Third-Level
Menu
Default Value Setting
Setting Wizard Site Unit Genset Qty 0 Set this
parameter as
required.
Tank Qty 1 Set this
parameter as
required.
12.2.9 Setting Parameters for the Reused DG
Step 1 Set parameters for the reused DG.
PowerCube 1000 (STC, Saudi Arabia, ICC800-A1-C2,
ESC800-A1)
Installation Guide 12 Power-on and Commissioning
Issue 02 (2021-09-28) Copyright © Huawei Technologies Co., Ltd. 128